S3012
Fountain solution additive for a broad range of applications at a standard alcohol concentration of 6 - 8% (vol.). Ideally suited for presses with copper rollers. In solutions with a concentration of 2.5 - 3%, it can be used for Moderate to hard water.
Fountain Solution Additive
BottcherFount S-3012 is a fountain solution additive for sheet-fed offset/Webfed/Heatset. For Moderate to hard water.
Features
1. Standard dosage 2 - 3 %
2. For IPA-reduction to 6 - 8 %
3. Very stable ink-/water balance
4. Reduced and stable water pick up of the ink, therefore higher ink densities obtained
5. Fast restarts and stable printing for long runs
6. For conventional and film dampening systems
7. Good printing plate protection
8. For water hardness 8 - 25° dH (total hardness)
9. pH-value 4.9 - 5.2 (according to water hardness)
10. Suitable for UV printing as well
11. Effective prevention of foam
12. Increased conductivity per % input: 480 μS/cm
13. Density 1.05 (kg/l)
Note
Before applying BottcherFount S-3012, the fountain system must be completely emptied and cleaned thoroughly, preferably using BottcherPro Hydroclean.
Use BottcherPro Calcit as a re-hardener for Ro and Modrate to Hard Water.
> Click Here to View PDF
|